Scientific blog
November K. Stan-Glowinska 
Friday, 6 December, 2013, 15:23
Posted by Katarzyna Stan
During November:
- I have been writing an introduction to my work
- I have prepared powders from ternary melt spun ribbons and obtained my first bulk samples by hot pressing
- I did some TEM studies on annealed samples of quaternary Al-Mn-Fe-Mo melts spun ribbons

view entry ( 88 views )   |  print article
November report (K.Glowinski) 
Friday, 6 December, 2013, 13:52
Posted by Krzysztof Glowinski
I was testing the method for finding
peaks in grain boundary distributions.
It seem that it is quite efficient, but
some control parameters and threshold
must be adjusted. I have been playing with
differen values of those parameters
for various data sets.

view entry ( 108 views )   |  print article
November 
Friday, 6 December, 2013, 11:10
Posted by Jakub Kawalko
In november new equipment for in-situ heating experiments for Quanta have arrived at the Institute. This new heating stage have important new functionality that provides opportunity for EBSD in-situ experiments. I have took the short, two days training that was provided by engineer who was in charge of installation of new system.
After the stage is installed and sample is properly attached to heating plate, actual heating of sample is relatively straight forward. The numerical value of desired temperature is specified by operator in dedicated software, and system automatically chooses needed voltage that is applied to heating element. Also the temperature is stabilised automatically by system and software and cooling facilities. At current time it is not possible to choose a slope by which the sample is heated and temperature raises almost instantaneously, therefore it is recommended to increase temperature in at most 100 degree steps with beam switched off (in order to maintain proper vacuum level). During the training samples of deformed aluminium alloy have been investigated, which was good introduction to in-situ recrystallization as I plan to perform such experiments on KoBo deformed titanium.
view entry ( 61 views )   |  print article
K.Kubok phD report (November 2013) 
Friday, 6 December, 2013, 10:07
Posted by Katarzyna Kubok
Today we have international Santa Claus day! I wish you all as many presents as you like :)
During past month I conctucted new study on hardening mechanism in MgZnCa alloys - longer times were used to observe precipitation evolution. New thin foils for TEM were prepared.
view entry ( 50 views )   |  print article
November report Z.Starowicz 
Thursday, 5 December, 2013, 15:46
Posted by Zbigniew Starowicz
During November:
- In case of photochemical method I prepared 4 different titanium dioxide substares and determined its influance on Ag nanoparticles formation. Ony for substrate annealed for 2h at 500 Celcsius the particles ware found.
- I was also adsorbing 100nm particles from commerial sollution( Ag cont. 20ppm , Zeta - 50 -V) and 50 -100nm particles solution from ICSP PAS ( Ag cont. 300ppm, Zeta - 30mV).
Larger particles covered abuot 4% of sample surface within 4 hour of deposition while smaller about 15 % quicker than 15minutes.
It means that concentration can be the most important parameter

view entry ( 89 views )   |  print article

<<First <Back | 27 | 28 | 29 | 30 | 31 | 32 | 33 | 34 | 35 | 36 | Next> Last>>